{"NAME":"Gosund UP111","GPIO":[0,320,0,32,2720,2656,0,0,2624,576,224,0,0,0],"FLAG":0,"BASE":18}

For more accurate energy consumption measurements this device requires power monitoring calibration.

WARNING: New Tuya devices have replaced their Wi-Fi module with one incompatible with Tasmota!!!
Tuya-Convert might not be possible for this device since the template was added (2022-08-10).

• 17-Mar-2023: Box of 2 bought from amazon.co.uk. All flashed OK with Tuya-Convert 2.4.5
• 16-Mar-2023: Bought these from amazon.co.uk, they are mark Gosund on the physical box but wont flash https://www.amazon.co.uk/dp/B09SDBSS3V from ONEPLUG UP111
• 11-Dec-2022: Box of 4 from amazon.co.uk (sold by OHMAXX). All flashed OK with Tuya-Convert
• 05-Dec-2022: box bought from amazon.co.uk - can not flash, tuya-convert reports “firmware too new”.
• 28-Nov-2022: box bought from amazon.co.uk. Would not flash via tuya-convert nor via serial. Not ESP8266, uses W701 chip - same as this
• 10-Nov-2022: 2 x box of 4 bought from amazon.co.uk. Could not flash with tuya-convert. socket reboots on resending smartconfig packets. Polish imported with no manufacturing date on devices.
• 22-Oct-2022: Received another lucky box of 4 from amazon.co.uk - the same reference to a Polish importer. This time NO manufacturing date on devices - flashed successfully with tuya-convert. No calibration needed.
• 21-Oct-2022: Box of 4 bought from amazon.co.uk, same as below - date of manufacture of 01/2021, reference to an importer in Poland, flashed OK. some devices booted into pairing mode, others required a long press of the button to get there.
• 20-Oct-2022: Box of 4 bought from amazon.co.uk and all 4 flashed successfully with tuya-convert. The manufacturing date on device is 01/2021. It also has some importer details based in Poland - both on the box and devices. I guess, I was lucky with the purchase of an old and supported model. No calibration needed.
• 01-Oct-2022: Box of 4 bought from amazon.co.uk and all 4 flashed successfully with tuya-convert. For these I didn’t have to push any button to enter flash mode (this actually prevented it from working).
• 27-Sep-2022: Box of 4 bought from eBay.co.uk, tuya-convert failed with firmware too new.
• 12-Sep-2022: Box of 4 bought from amazon.co.uk and flashed successfully with tuya-convert.
• 10-Sep-2022: Box of 4 bought from uk.gosund.com and flashed successfully with tuya-convert.
• 28-Aug-2022: 2 x Box of 4 bought from amazon.co.uk and flashed successfully with tuya-convert.
• 08-Aug-2022: Box of 4 bought from amazon.co.uk and flashed successfully with tuya-convert.
• 25-Jun-2022: Box of 4 bought from amazon.co.uk and flashed successfully with tuya-convert. Also box of 4 purchased from ebay link added above and also all 4 flashed successfully.

Change GPIO13 to Led_i2 for red LED = Power ON; OR use template: {"NAME":"Gosund UP111","GPIO":[0,320,0,32,2720,2656,0,0,2624,321,224,0,0,0],"FLAG":0,"BASE":18}