Wireless Tag ESP32 Ethernet Development Board (WT32-ETH01)
Wireless Tag ESP32 Ethernet
GPIO #Component
GPIO00 User
GPIO01 User
GPIO02 User
GPIO03 User
GPIO04 User
GPIO05 User
GPIO09 None
GPIO10 None
GPIO12 User
GPIO13 None
GPIO14 User
GPIO15 User
GPIO16 Output Hi
GPIO17 LedLinki
GPIO18 SHD Reset
GPIO19 None
GPIO20 None
GPIO21 None
GPIO22 None
GPIO23 SHD Boot 0
GPIO24 None
GPIO25 None
GPIO26 None
GPIO27 None
GPIO6 None
GPIO7 None
GPIO8 None
GPIO11 None
GPIO32 User
GPIO33 User
GPIO34 None
GPIO35 User
GPIO36 User
GPIO37 None
GPIO38 None
GPIO39 User
Configuration for ESP32

To use this device, you have to compile Tasmota with Ethernet enabled. Download unofficial precompiled firmware from development branch.

Set in user_config_override.h

  // Wireless-Tag WT32-ETH01
  #define ETH_TYPE          0                    // [EthType] 0 = ETH_PHY_LAN8720, 1 = ETH_PHY_TLK110, 2 = ETH_PHY_IP101
  #define ETH_ADDRESS       1                    // [EthAddress] 0 = PHY0 .. 31 = PHY31
  #define ETH_CLKMODE       0                    // [EthClockMode] 0 = ETH_CLOCK_GPIO0_IN, 1 = ETH_CLOCK_GPIO0_OUT, 2 = ETH_CLOCK_GPIO16_OUT, 3 = ETH_CLOCK_GPIO17_OUT

Or use commands EthType 0, EthClockMode 0 and EthAddress 1