Matter A19 9W 800lm RGBCCT Bulb (FL_L85)
Available from:
Aliexpress.com
Install method:
Replace module
| GPIO # | Component |
|---|---|
| GPIO00 | None |
| GPIO01 | None |
| GPIO02 | None |
| GPIO03 | None |
| GPIO04 | BP5858D Clk |
| GPIO05 | BP5858D Dat |
| GPIO06 | None |
| GPIO07 | None |
| GPIO08 | None |
| GPIO09 | None |
| GPIO10 | None |
| GPIO12 | None |
| GPIO13 | None |
| GPIO18 | None |
| GPIO19 | None |
| GPIO20 | None |
| GPIO21 | None |
Configuration for ESP32-C3
{"NAME":"FL_L85","GPIO":[0,0,0,0,9024,9056,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0],"FLAG":0,"BASE":1,"CMND":"SO37 54"}
This device uses
ESP8684-WROOM-07
module which needs to be replaced with
an ESP. Besides the module, this process will require a heat gun, soldering tools and moderate soldering skill.
Use ‘SetOption37 54’ to set colors.
This is a Matter bulb running on an ESP32-C2 ESP8684-WROOM-07 module with encrypted flash which means it cannot be flashed to Tasmota. It is replaced with a pin compatible ESP8685-WROOM-07.
Squeeze the plastic dome and pop it off. Scrape off the white glue on the edges of the bulb and lift the circular PCB with LEDs to get access to the ESP module. Use a heat gun to remove it from the main PCB and replace.
