{"NAME":"Tuya Remote","GPIO":[1,1,1,1088,1056,1,32,544,1,1,1,0,0,0,0,0,0,0,1,1,1,1],"FLAG":0,"BASE":1}

This device uses a Tasmota incompatible module which needs to be replaced with an ESP. Besides the module, this process will require a heat gun, soldering tools and moderate soldering skill.

Hardware:

Tuya Remote Control S08 contains Beken chip (CBU), this needs to be desoldered and replaced preferably with ESP32-C3-05. CBU pinout is almost similar to ESP32-C3-05, and since only the bottom CBU pins are required. You wouldn’t need to solder the pins on the left & right side.

Firmware:

For extended irhvac support, compile tasmota firmware for esp32-c3, add below:

#define USE_IR_REMOTE_FULL

in the user_config_override.h