Antsig Universal Remote Controller IR Controller (HUBIR01HA)
Antsig Universal Remote Controller

Available from:

Install method:
USB to Serial

GPIO #Component
GPIO00 User
GPIO01 User
GPIO02 User
GPIO03 User
GPIO04 Led_i 1
GPIO05 IRrecv
GPIO09 None
GPIO10 None
GPIO12 None
GPIO13 Button 1
GPIO14 IRsend
GPIO15 None
GPIO16 None
GPIO17 None
{"NAME":"Antsig Smart Wi-Fi IR","GPIO":[1,1,1,1,320,1088,0,0,0,32,1056,0,0,0],"FLAG":0,"BASE":62}

This device now comes with a Wi-Fi module incompatible with Tasmota

Warning! Since 2022-03-19 ships with an incompatible Tuya CB3S. If the box says “HUBIR01HA Series 2” its likley its the incompatible chip.

It is possible to replace the incompatible CB3S chip with a ESP-12 S/E/F. If you do, depending on your chip you may need to pull GPIO15 down to ground with a 10k resistor for the ESP device to boot

Old hardware instructions

You will need to flash the tasmota-ir.bin firmware to this deivce.