Available from:
Aliexpress.com
Manufacturer:
Athom.tech
Install method:
Tasmota pre-installed
| GPIO # | Component |
|---|---|
| GPIO00 | None |
| GPIO01 | None |
| GPIO02 | None |
| GPIO03 | Button 1 |
| GPIO04 | None |
| GPIO05 | Relay 1 |
| GPIO06 | LedLinki |
| GPIO07 | None |
| GPIO08 | None |
| GPIO09 | None |
| GPIO10 | None |
| GPIO12 | None |
| GPIO13 | None |
| GPIO18 | None |
| GPIO19 | None |
| GPIO20 | CSE7766 Rx |
| GPIO21 | None |
{"NAME":"Athom Plug V3","GPIO":[0,0,0,32,0,224,576,0,0,0,0,0,0,0,0,0,0,0,0,0,3104,0],"FLAG":0,"BASE":1}
For more accurate energy consumption measurements this device requires power monitoring calibration.
HLW8032 occasionally report invalid power measurements for load values below 5W. During this situation it sometimes reports a valid load. By setting SetOption39 to 128 (default) it must read at least 128 invalid power readings before reporting there is no load.
To discard all loads below 6W simply set SetOption39 1 (0 will reset to default on next restart) so it will report no load below 6W.