BlitzWolf Curtain Module (BW-SS6)

Available from:


Install method:
USB to Serial

GPIO #Component
GPIO00 None
GPIO01 None
GPIO02 Button 1
GPIO03 None
GPIO04 Buzzer
GPIO05 None
GPIO09 None
GPIO10 None
GPIO12 Switch 2
GPIO13 Switch 1
GPIO14 Relay 1
GPIO15 Relay 2
GPIO16 None
GPIO17 None
{"NAME":"BlitzWolf SS6 2 Gang","GPIO":[0,0,32,0,480,0,0,0,161,160,224,225,0,0],"FLAG":0,"BASE":18}
Use code BLAKADDER23 when buying from mediarath.de Tasmota category and a minimum order value of 50€ for a 10% discount. The code is valid until end of 2023.

This device uses the LM1 tuya chip which is based on the ESP8266EX chipset.

Using this template turns the unit into a simple 2-gang switch (eg. like BW-SS5 [2 gang]).

To operate the unit as a roller shutter switch, the following commands should be issued:

  • enable Interlock 1,2
  • activate Interlock on
  • set the switches to follow and inverse SwitchMode1 2 and SwitchMode2 2. Check SwitchModes documentation for details.
  • Then the device should be calibrated for the distance of your curtains, have a look at Blinds and Shutters configuration page.

Serial Flashing

It is possible to flash the unit serial method using an USB-TTL adapter. The I/O wiring endpoints are available in the images below, no soldering is required.