Cleverio 51395 806lm RGBCCT Bulb
Available from:
Kjell.com
Install method:
USB to Serial
| GPIO # | Component |
|---|---|
| GPIO00 | None |
| GPIO01 | None |
| GPIO02 | None |
| GPIO03 | None |
| GPIO04 | SM16716 DAT |
| GPIO05 | SM16716 CLK |
| GPIO09 | None |
| GPIO10 | None |
| GPIO12 | PWM 2 |
| GPIO13 | SM16716 PWR |
| GPIO14 | PWM 1 |
| GPIO15 | None |
| GPIO16 | None |
| GPIO17 | None |
Configuration
{"NAME":"CleverioE27RGB","GPIO":[0,0,0,0,2944,2912,0,0,417,2976,416,0,0,0],"FLAG":0,"BASE":18}Configuration (old format, will be converted to new template when applied)
{"NAME":"CleverioE27RGB","GPIO":[0,0,0,0,140,37,0,0,38,142,141,0,0],"FLAG":0,"BASE":18}{"NAME":"CleverioE27RGB","GPIO":[0,0,0,0,37,40,0,0,38,41,39,0,0],"FLAG":0,"BASE":18}TYLC6E is the controller used in the device.
To flash it, you will need to solder wires onto the solder pads labeled “RX”, “TX”, “IO0”, “3V3” and “GND”. “IO0” needs to be grounded for the device to enter flashing mode.
Also, this device does not use SM16716 LED driver, but uses BP5778 and therefore uses PWM channels for all the colors + whites.
SetOption68 1 will have to be used to enable separate PWM control.
Some versions use the TYWE3L. Use alternate template for those.