DoHome HomeKit DIY Switch Relay Board
Available from:
Aliexpress.com
Manufacturer:
Github.com
| GPIO # | Component |
|---|---|
| GPIO00 | User |
| GPIO01 | User |
| GPIO02 | None |
| GPIO03 | User |
| GPIO04 | Button1i |
| GPIO05 | LedLink |
| GPIO09 | None |
| GPIO10 | None |
| GPIO12 | Relay1 |
| GPIO13 | None |
| GPIO14 | None |
| GPIO15 | None |
| GPIO16 | None |
| FLAG | None |
Configuration (old format, will be converted to new template when applied)
{"NAME":"DoHome DIY","GPIO":[255,255,0,255,122,157,0,0,21,0,0,0,0],"FLAG":0,"BASE":1}
Flashing
Enter flash mode with the jumper on both mode mode pins and connect your serial-to-USB adapter to TX, RX, GND and 5V (use 3.3V pin from your adapter).
Switching
Optionally, replacing 122 with 9 in the config above will allow use as a contact sensor instead of a button.
