Logo
Electrodragon ESP LED Strip Board, Mosfet Drive LED Controller
Electrodragon ESP LED Strip Board, Mosfet Drive

Available from:
Electrodragon.com







GPIO #Component
GPIO00 None
GPIO01 None
GPIO02 None
GPIO03 None
GPIO04 None
GPIO05 None
GPIO09 None
GPIO10 None
GPIO12 PWM3
GPIO13 PWM2
GPIO14 PWM4
GPIO15 PWM1
GPIO16 Led1
FLAG None
Configuration (old version)
{"NAME":"LEDBoard RGBW","GPIO":[0,0,0,0,0,0,0,0,39,38,40,37,52],"FLAG":0,"BASE":18}

Alternative template for WS2812 LEDs:

Template {"NAME":"LEDBoard W2812","GPIO":[0,0,7,0,0,0,0,0,0,0,0,0,52],"FLAG":0,"BASE":18}

Description

  • Based on ESP8266 Wifi IC, ESP-12F module.
  • One channel RGB LED strips (can also be used for three channels LED strips)
  • One extra channel white LEd strips.
  • Jumper select to support WS2812 LED strips or ring board.
  • Input voltage 6-27V, also power LED strip, if LED strip is 12V, input voltage should be 12V. For WS2812, input voltage should use 5V.
  • On board Mosfet control is FR1205, support up to 44A/55V, for low light 5050 white led strip is about 0.4A 12V(5W), so technically support up to 100 meter per channel.
  • Lead out all extra pins of ESP-12F for other use. Two buttons – flash and reset.
  • Package Inlcudes:
    • Main control board
    • Plastic case kit (smaller than ESP relay board.)
    • DC5.5-2.1CM power input cable
    • RGB connecting cable
    • normal 5050 white LED strip (10CM width) cable.