Logo
Gosund P2 Power Strip (2APUZ-P2)
US
Gosund P2

Available from:
Amazon.com
Amazon.com




Manufacturer:
Alibaba.com

Install method:
Tuya-Convert

GPIO #Component
GPIO00 None
GPIO01 None
GPIO02 LedLinki
GPIO03 None
GPIO04 None
GPIO05 None
GPIO09 None
GPIO10 None
GPIO12 Relay 1
GPIO13 Relay 2
GPIO14 Relay 3
GPIO15 Relay_i 4
GPIO16 Button 1
GPIO17 None
Configuration
{"NAME":"Gosund-PM03-v2","GPIO":[0,0,576,0,0,0,0,0,224,225,226,259,32,0],"FLAG":0,"BASE":18}
Tuya-Convert might not be possible for this device since the template was added (2021-10-09). All new Tuya devices have firmware preventing flash but it is still possible to Tuya-Convert old stock devices without connecting them to the Tuya app.

This device uses triangle screws, but they are easily accessed, and the unit is easily opened otherwise. Points for serial flashing are on the back side of the board after opening the case. These points are clearly labeled for G, Vcc, Rx, Tx, and IO0. Soldering on temporary pigtail wires for the serial flash is highly recommended. The points are too far from the edge of the board to use probe type spring clips.

Some additional suggested console modifications to do after flashing and configuring the template are listed below

Label the web-buttons to match the template

backlog webbutton1 Plug1; webbutton2 Plug2; webbutton Plug3; webbutton4 USB

Rule for turning all the outlets off with a long press of the physical button.

rule1 on button1#state=3 do power0 off endon
rule1 on

The FCC documents indicate that this board design was used under other model names including: PM03, PM02, PM01, WB2, WB4, LB1, LB2, P3, WO1, WO2

Reddit thread