Logo
Lenovo SE-141DC CCT Bulb
E26
Model reference: ZA7G0000WW
Lenovo SE-141DC

Available from:
Lowes.com




Manufacturer:
Lenovo.com

Flashed with:
Serial port

GPIO #Component
GPIO00 None
GPIO01 None
GPIO02 None
GPIO03 None
GPIO04 None
GPIO05 PWM 1
GPIO09 None
GPIO10 None
GPIO12 None
GPIO13 PWM 2
GPIO14 None
GPIO15 None
GPIO16 None
GPIO17 None
Template for Tasmota v9.1+
{"NAME":"LenovoSE-141DC","GPIO":[0,0,0,0,0,416,0,0,0,417,0,0,0,0],"FLAG":0,"BASE":48}

Open bulb (I just put seam of bulb on the edge of furniture and pushed down on both sides of the bulb to pop it open). Remove LED board (has a connector, doesn’t require un-soldering). Connect VCC/GND/TX/RX on module to programmer. Connect GPIO0 on module to GND with 9kohm resistor when applying power to module (to enter programming mode).