LifeSmart Cololight MIX RGBIC LED (LS168)
Available from:
Banggood.com
Amazon.com
Install method:
USB to Serial
| GPIO # | Component |
|---|---|
| GPIO00 | None |
| GPIO01 | None |
| GPIO02 | None |
| GPIO03 | None |
| GPIO04 | WS2812 1 |
| GPIO05 | None |
| GPIO09 | None |
| GPIO10 | None |
| GPIO12 | None |
| GPIO13 | None |
| GPIO14 | None |
| GPIO15 | None |
| GPIO16 | None |
| GPIO17 | None |
| GPIO18 | None |
| GPIO19 | None |
| GPIO20 | None |
| GPIO21 | None |
| GPIO22 | None |
| GPIO23 | None |
| GPIO24 | None |
| GPIO25 | None |
| GPIO26 | None |
| GPIO27 | Button 1 |
| GPIO6 | None |
| GPIO7 | None |
| GPIO8 | None |
| GPIO11 | None |
| GPIO32 | None |
| GPIO33 | ADC Input 1 |
| GPIO34 | None |
| GPIO35 | None |
| GPIO36 | None |
| GPIO37 | None |
| GPIO38 | None |
| GPIO39 | None |
Configuration for ESP32
{"NAME":"ESP32-DevKit","GPIO":[0,0,0,0,1376,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,32,0,0,0,0,0,4704,0,0,0,0,0,0],"FLAG":0,"BASE":1}Each MIX has 37 LEDs, use Pixels command to set the right number of LEDs.
Microphone is mapped to Analog input but there is no support for sound reactive effects in Tasmota.
Flashing
Use a prying tool or a spudger to separate back plate from the shell.
Take out the PCB, the flashing pads are located left of the ESP32 module.
Connect your serial to USB adapter to TX, RX and GND. Power the controller using its USB-C port. Ground the GPIO0 (bottom hole) during powerup.