Lohas ZN006 1380lm RGBW Bulb (LH-ZN006-RGB-A21-N1)
Available from:
Amazon.com
Lohas-led.com
Manufacturer:
Lohasled.com
| GPIO # | Component |
|---|---|
| GPIO00 | None |
| GPIO01 | None |
| GPIO02 | None |
| GPIO03 | None |
| GPIO04 | None |
| GPIO05 | None |
| GPIO09 | None |
| GPIO10 | None |
| GPIO12 | None |
| GPIO13 | MY92x1 DI |
| GPIO14 | None |
| GPIO15 | MY92x1 DCKI |
| GPIO16 | None |
| FLAG | None |
Configuration (old format, will be converted to new template when applied)
{"NAME":"Lohas100 RGBW","GPIO":[0,0,0,0,0,0,0,0,0,143,0,144,0],"FLAG":0,"BASE":18}
See Tasmota documentation on how to configure RGBW lights to your needs.
Side note if you do need to attach to the bulb via USB serial the pads are there right under the light diffuser to easily solder RX, TX, GND, and GPIO0 but 3v3 does not work. You will need to solder to the flash memory chip VCC leg to inject 3v3 power, it is easier to solder to this pin instead of the ESP8266 directly.