Logo
LoraTap In-Wall Curtain Module (SC500W)
EU
LoraTap In-Wall

Available from:
Loratap.com
Aliexpress.com




Manufacturer:
Loratap.com

Install method:
Tuya-Convert

GPIO #Component
GPIO00 None
GPIO01 None
GPIO02 None
GPIO03 LedLinki
GPIO04 Switch1
GPIO05 Switch2
GPIO09 None
GPIO10 None
GPIO12 Relay1
GPIO13 Button1
GPIO14 Relay2
GPIO15 None
GPIO16 None
FLAG None
Configuration (old format, will be converted to new template when applied)
{"NAME":"SC500W","GPIO":[0,0,0,158,9,10,0,0,21,17,22,0,0],"FLAG":0,"BASE":18}
WARNING: New Tuya devices have replaced their Wi-Fi module with one incompatible with Tasmota!!!
Tuya-Convert might not be possible for this device since the template was added (2019-12-26).

WARNING! LoraTap is using ESP8266 and Realtek Wi-Fi modules on same model devices. Check seller descriptions or contact them before buying!

Using this template turns the unit into a simple 2-gang switch (eg. like a Sonoff Dual, but with extra connections to a 2-gang wall switch).

To operate the unit as a roller shutter switch , the following commands should be issued:

  • switch on Interlock
  • set the switches to follow and inverse SwitchMode1 2 and SwitchMode2 2. Have a look at [https://tasmota.github.io/docs/Buttons-and-Switches?id=switchmode]
  • set the shutter runtime with PulseTime1 <time in sec+100> and PulseTime2 <time in sec+100>. Have a look at [https://tasmota.github.io/docs/Commands?id=pulsetime]

Serial Flashing

It is possible to flash the unit also by the traditional method using an USB-TTL adapter. The pad named IOO on the back of the ESP module has to be connected to GND during the flash procedure. Successfully flashed using Tasmotizer.