Maxcio WF-CS01 Curtain Switch (WF-CS01)
Maxcio WF-CS01

Available from:

Install method:

GPIO #Component
GPIO00 LedLink
GPIO01 None
GPIO02 Led2
GPIO03 Switch3
GPIO04 Relay3
GPIO05 Button2
GPIO09 None
GPIO10 None
GPIO12 Button1
GPIO13 Relay1
GPIO14 Led3
GPIO15 Relay2
GPIO16 Led1
Configuration (old format, will be converted to new template when applied)
Requires configuring shutter support.

WARNING: New Tuya devices have replaced their Wi-Fi module with one incompatible with Tasmota!!!
Tuya-Convert might not be possible for this device since the template was added (2020-09-22).

Configure Tasmota shutter support, then also apply these rules.

SetOption80 1 # Enable shutter support, reset the device after for correct interface to show up

ShutterRelay1 1 # Enable shutter relay 1

Backlog PulseTime1 0; PulseTime2 0 # ShutterMode0

Pulsetime3 1 # auto disable Power3 button

Backlog Interlock 1,2,3; Interlock ON

PowerRetain 1 # Save state for Home Assistant

Rule1 on Power3#State=1 do ShutterStop1 endon # Use the middle button for stopping shutter movement

Rule1 1

Rule2 on Power1#State=0 do LEDPower1 0 endon on Power1#State=1 do LEDPower1 1 endon on Power2#State=0 do LEDPower2 0 endon on Power2#State=1 do LEDPower2 1 endon on Power3#State=0 do LEDPower3 0 endon on Power3#State=1 do LEDPower3 1 endon # Giving color on button press

Rule2 1

WebButton3 ■ # Set stop symbol for the third button in the web GUI

SwitchMode1 4 # Make the buttons do their actions on touch, not release

SwitchMode2 4

SwitchMode3 4