Moes 2 Gang Dimmer Module (MS-105B)
Moes 2 Gang

Available from:

Install method:
Replace module

GPIO #Component
GPIO00 None
GPIO01 Tuya Tx
GPIO02 None
GPIO03 Tuya Rx
GPIO04 None
GPIO05 None
GPIO09 None
GPIO10 None
GPIO12 None
GPIO13 None
GPIO14 None
GPIO15 None
GPIO16 None
GPIO17 None
{"NAME":"WM-105","GPIO":[0,2272,0,2304,0,0,0,0,0,0,0,0,0,0],"FLAG":0,"BASE":54,"CMND":"TuyaMCU 11,1 | TuyaMCU 21,2 | TuyaMCU 12,7 | TuyaMCU 22,8 | DimmerRange 0,1003"}
This device uses WB2S module which needs to be replaced with ESP-02S, WT-01N or WT32C3-01N module. Besides the module, this process will require a heat gun, soldering tools and moderate soldering skill. Read more about module replacement in a detailed guide.

Use code BLAKADDER when buying from moeshouse.com store for a 20% discount.

2 Channels Dimmer switch ready, local control with two reset switches. Red LED is for first channel, blue led for second channel.

At dpID 6 and dpID12 are a nightlight-Option. If you set this integer higher then 1, the light will go off set the dimmer-level to 151. With next set the same parameter or set on with dpID 1 or 7, the light will illuminate at “night light level”.

At dpID4 and dpID10 are enums with 0..6 which dont do anything.