Prime Outdoor Plug (CCRCOWF2PK)

Available from:

Install method:
Replace module

GPIO #Component
GPIO00 User
GPIO01 User
GPIO02 User
GPIO03 User
GPIO04 Led 1
GPIO05 Switch 1
GPIO09 User
GPIO10 User
GPIO12 User
GPIO13 Relay 1
GPIO14 User
GPIO15 User
GPIO16 User
GPIO17 User
This device uses CB2S module which needs to be replaced with ESP-02S, WT-01N or WT32C3-01N. Besides the module, this process will require a heat gun, soldering tools and moderate soldering skill.

The unit is easily disassembled. Remove 6 Philips screws on bottom side and the bottom half of the housing can be slide out from the top. Remove the two Philips screws which attach the main board to the top half of the housing. Desolder CB2S module from main board. Using a solder wick to remove the solder on the pins on either side of the module works well. Replace with ESP-02S module flashed with Tasmota.