Ucomen Outdoor Plug (PA-GEBA-01SWP) Configuration for Tasmota

Ucomen Outdoor Plug (PA-GEBA-01SWP)

Available from:
Amazon.de

Manufacturer:
Expo.tuya.com

Install method:
USB to Serial

GPIO #	Component
GPIO00	None
GPIO01	None
GPIO02	None
GPIO03	None
GPIO04	Led1
GPIO05	Led2i
GPIO09	None
GPIO10	None
GPIO12	Relay1
GPIO13	Button1
GPIO14	None
GPIO15	None
GPIO16	None
FLAG	None

Configuration (old format, will be converted to new template when applied)

{"NAME":"PA-GEBA-01SWP","GPIO":[0,0,0,0,52,57,0,0,21,17,0,0,0],"FLAG":0,"BASE":18}

2021/02/17 Tuya-convert OTA failed for this plug due to its factory loaded Tuya firmware (PSK identity 02).

This plug contains a TYWE2S.

To open the shell of the device the green rubber cap have to be pulled up and two tri-wing security screws have to be removed. To flash, wires have to be soldered to 3.3v, GND, TX, RX and GPI0(to GND). Remember to swap RX and TX on your FTDI board!

Pinout (WIFI3680-14-V1-2):

GPI0 sits just behind a capacitor that needs to be desoldered. Pinout (TYWE2S):