{"NAME":"PA-GEH-01SW2","GPIO":[0,0,0,32,2688,2656,0,0,2624,320,224,0,0,0],"FLAG":0,"BASE":18}

For more accurate energy consumption measurements this device requires power monitoring calibration.

Top plate is glued on a box, containing the PCB. PCB is on the bottom, so be careful to drill a hole for disassembly. Took me a while, but I succeeded disassembly useing a hair dryer to soften the glue and pry a screwdriver to open the case.

Uses a TYWE2S module. It didn’t allow tuya-convert via wifi. I had soldered the required wires for a serial flash to the locations that I had found on the board. However, it wasn’t found via NodeMcu Pyflasher. I completely desoldered the TYWE2S frmo the main board as it seemed as if teh TX and RX connectors where going somewhere on the board, e.g. to a switch. Serial flashing it separately without a connection to the board of the plug worked.

Pinout

.