Yagusmart 2 Gang Wall Light Switch (DS-101)
Available from:
Amazon.co.uk
Install method:
USB to Serial
| GPIO # | Component |
|---|---|
| GPIO00 | LedLink |
| GPIO01 | Led_i 2 |
| GPIO02 | None |
| GPIO03 | Button_n 1 |
| GPIO04 | Relay 2 |
| GPIO05 | Button_n 2 |
| GPIO09 | None |
| GPIO10 | None |
| GPIO12 | None |
| GPIO13 | Relay 1 |
| GPIO14 | Led_i 1 |
| GPIO15 | None |
| GPIO16 | None |
| GPIO17 | None |
Configuration
{"NAME":"DS-101 2 Gang","GPIO":[544,321,0,64,225,65,0,0,0,224,320,0,0,0],"FLAG":0,"BASE":18}While it’s marked as DS-101 on the back, the other DS-101 templates didn’t work, so I created this one instead.
Connections:
| Serial | Board |
|---|---|
| 3.3V | VCC |
| GND | GND |
| GND | GPIO0 |
| RX | TXD0 |
| TX | RXD0 |
As shown in the image, resistor R49 will need to be removed, as it interferes with the flashing process. It’s just a 0 ohm resistor, so if it’s too small for you to reliably resolder, just use a small blob of solder to bridge the pads.
