Available from:
Banggood.com
Aliexpress.com
Amazon.de
Manufacturer:
En.yeelight.com
Install method:
USB to Serial
| GPIO # | Component |
|---|---|
| GPIO00 | None |
| GPIO01 | None |
| GPIO02 | None |
| GPIO03 | None |
| GPIO04 | None |
| GPIO05 | PWM 3 |
| GPIO09 | None |
| GPIO10 | None |
| GPIO12 | None |
| GPIO13 | PWM 1 |
| GPIO14 | PWM 2 |
| GPIO15 | None |
| GPIO16 | None |
| GPIO17 | None |
| GPIO18 | None |
| GPIO19 | None |
| GPIO20 | None |
| GPIO21 | None |
| GPIO22 | None |
| GPIO23 | None |
| GPIO24 | None |
| GPIO25 | None |
| GPIO26 | None |
| GPIO27 | None |
| GPIO6 | None |
| GPIO7 | None |
| GPIO8 | None |
| GPIO11 | None |
| GPIO32 | None |
| GPIO33 | None |
| GPIO34 | None |
| GPIO35 | None |
| GPIO36 | None |
| GPIO37 | None |
| GPIO38 | None |
| GPIO39 | None |
{"NAME":"Yeelight Lightstrip 1S","GPIO":[0,0,0,0,0,418,0,0,0,416,417,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0],"FLAG":0,"BASE":1,"CMND":"SO37 128 | SO92 1"}tasmota32solo1... binaries.
Applying the template will add two SetOptions to allow both PWM lights to be controlled: SetOption37 128 and SetOption92 1
As it’s highlighted in Yeelight Pendant Light
- GPIO5 - Blue (PWM3)
- GPIO13 - Red (PWM1)
- GPIO14 - Green (PWM2)
Additional info about GPIOs - those are not covered by this template.
- GPIO4 - Controls Blue Led (on-board)
- GPIO16 - Controls Orange Led (on-board)
- GPIO19 - Button
Please note, there is also a physical button on this device, however it has not been determined which GPIO it has assigned.
All pins necessary for flashing are on the module. 