ZUCZUG 3 Gang Switch (Wifi-w6b 2ph105626a)
Available from:
Aliexpress.com
Install method:
Tuya-Convert
| GPIO # | Component |
|---|---|
| GPIO00 | None |
| GPIO01 | Led1 |
| GPIO02 | None |
| GPIO03 | Button1 |
| GPIO04 | Button3 |
| GPIO05 | Button2 |
| GPIO09 | None |
| GPIO10 | None |
| GPIO12 | Relay2 |
| GPIO13 | Relay1 |
| GPIO14 | Relay3 |
| GPIO15 | None |
| GPIO16 | None |
| FLAG | None |
Configuration (old format, will be converted to new template when applied)
{"NAME":"2ph105626a x3","GPIO":[0,52,0,17,19,18,0,0,22,21,23,0,0],"FLAG":0,"BASE":1}
WARNING: New Tuya devices have replaced their Wi-Fi module with one incompatible with Tasmota!!!
Tuya-Convert might not be possible for this device since the template was added (2020-03-26).
Tuya-Convert might not be possible for this device since the template was added (2020-03-26).
Open it up, disconnect it from the switching board from the bottom(just pull it off)
2ways of flashing:
disconnect the route pin (6nd from top on the right (dot is up left))
pulling rst LOW (1th from top on the left (dot is up left))
