Logo

ZZHXON 600lm RGBCCT Bulb

ZZHXON 600lm

Available from:
Aliexpress.com






GPIO #Component
GPIO00 None
GPIO01 None
GPIO02 None
GPIO03 None
GPIO04 PWM4
GPIO05 PWM5
GPIO09 None
GPIO10 None
GPIO12 PWM2
GPIO13 PWM3
GPIO14 PWM1
GPIO15 None
GPIO16 None
FLAG None

Template

{"NAME":"E27_RGB_Bulb","GPIO":[0,0,0,0,40,41,0,0,38,39,37,0,0],"FLAG":0,"BASE":18}

General info

No branding on bulb body or on website I bought it from. Its simply labeled as Smart Wifi LED Bulb. The PCB is marked FL-L24-V2.1 and its available in E27/E14. It has separate cold and warm LED + 4 RGB LED. ESP8266EX chip and BP2516F Non-isolated CCCV driver IC.

Once you take PCB out you do not need to separate PCBs. All pins are easily solderable except IO0 which you must pull to ground for 5s in order to enter flashing mode. I made Y-splitter cable to easily connect IO0 to ground. One male jumperwire soldered on GND pin and other I held by hand to touch IO0 pin.

Setup

Commands I ran to get this running

  • SerialLog 0
  • SetOption15 1

You can also set Home Assistant auto discovery on with command SetOption19 1 after configuring MQTT.

Images

Packaging


Cap open


ESP8266EX


BP2516F


3.3V, TXD, RXD, GPIO0 and GND pins

Images in Imgur gallery