Logo
Deta Single Gang Touch Dimmer Dimmer (6910HA)
AU
Deta Single Gang Touch Dimmer

Available from:
Bunnings.com.au





Manufacturer:
Detaelectrical.com.au

Install method:
Replace module

GPIO #Component
GPIO00 None
GPIO01 Serial Tx
GPIO02 User
GPIO03 Serial Rx
GPIO04 None
GPIO05 None
GPIO09 None
GPIO10 None
GPIO12 None
GPIO13 None
GPIO14 None
GPIO15 None
GPIO16 None
GPIO17 None
Configuration
{"NAME":"Deta 6910HA","GPIO":[0,3200,1,3232,0,0,0,0,0,0,0,0,0,0],"FLAG":0,"BASE":54}
This device uses WR3 module which needs to be replaced with ESP8685-WROOM-01, ESP-12, ESP-C3-12F, ESP-12H, ESPC2-12 or ESP8684-WROOM-01C. Read more about module replacement in a detailed guide.

Requires replacement of module which is a ““WR3”” Realtek unit with an ESP8266/ESP12S. As the unit is controlled by an MCU, it needs Tasmota console commands for it to work. These commands are:

Backlog TuyaMCU 11,1;TuyaMCU 21,2, DimmerRange 280-1000

Note that the dimmer minimum value by default is 280. This can be increased by use of a potentiometer under the front cover of the unit, but doing so would cause some confusion as to why Tasmota or Home Assistant can set values as low as 280 but the button on the front of the unit is limited to the values dictated by the potentiometer.