LSC Smart Mood Light (3004154)
Available from:
Action.com
Install method:
Replace module
| GPIO # | Component |
|---|---|
| GPIO00 | None |
| GPIO01 | None |
| GPIO02 | None |
| GPIO03 | None |
| GPIO04 | PWM1 |
| GPIO05 | PWM4 |
| GPIO09 | None |
| GPIO10 | None |
| GPIO12 | PWM2 |
| GPIO13 | PWM5 |
| GPIO14 | PWM3 |
| GPIO15 | None |
| GPIO16 | None |
| FLAG | None |
Configuration (old format, will be converted to new template when applied)
{"NAME":"LSC Mood Light","GPIO":[0,0,0,0,37,40,0,0,38,41,39,0,0],"FLAG":0,"BASE":18}
This device uses
CB3S
module which needs to be replaced with
ESP8685-WROOM-01, ESP-12, ESP-C3-12F, ESP-12H, ESPC2-12 or ESP8684-WROOM-01C. Read more about module replacement in a detailed guide.
The button is on GPIO16, but as this pin does not have an internal pullup you need to pull it up externally e.g. with a 10k resistor from VCC. After that you can assign “Button_n” to GPIO16 in the Tasmota template.
GPIO=
R 4 G 12 B 14 CW 5 WW 13
Here are some pictures from the inside:
