MiBoxer RGB+CCT LED Controller (FUT039W)
Available from:
Aliexpress.com
Install method:
Replace module
| GPIO # | Component |
|---|---|
| GPIO00 | None |
| GPIO01 | None |
| GPIO02 | None |
| GPIO03 | None |
| GPIO04 | None |
| GPIO05 | None |
| GPIO06 | None |
| GPIO07 | None |
| GPIO08 | None |
| GPIO09 | None |
| GPIO10 | None |
| GPIO12 | None |
| GPIO13 | None |
| GPIO18 | None |
| GPIO19 | None |
| GPIO20 | Tuya Rx |
| GPIO21 | Tuya Tx |
Configuration for ESP32-C3
{"NAME":"FUT039W","GPIO":[0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,2304,2272],"FLAG":0,"BASE":54,"CMND":"DimmerRange 0,1000 | TuyaMCU 11,20 | TuyaMCU 26,21 | TuyaMCU 21,22 | TuyaMCU 23,23 | TuyaMCU 24,24 | TuyaMCU 98,101"}
This device uses
WBR3
module which needs to be replaced with
ESP8685-WROOM-01, ESP-12, ESP-C3-12F, ESP-12H, ESPC2-12 or ESP8684-WROOM-01C. Read more about module replacement in a detailed guide.
Hardware
The chip used on this board is a WBR3, and requires a transplant. It cannot be flashed. The daughterboard for the SoC is compatible with the ESP12-S. Other formats may be compatible, but may require jumper wires.
The TuyaMCU on board requires the following settings for an RGB+CCT strip.
Backlog DimmerRange 0,1000; TuyaMCU 11,20; TuyaMCU 26,21; TuyaMCU 21,22; TuyaMCU 23,23; TuyaMCU 24,24;
Serial Flashing
Please see the Hardware Preparation page for general instructions.
Post Transplant Photos
